Pinnacle Systems Universal Safety Controller HUB - Manual (Page 24)

Page 19 of 18
WARRANTY
Manufacturer warrants that this product will be free from defects in material and workmanship for a period of two years
from the date of shipment thereof. Within the warranty period, manufacturer will repair or replace such products which are
returned to it with shipping charges prepaid and which will be disclosed as defective upon examination by the manufacturer.
This warranty will not apply to any product which will have been subject to misuse, negligence, accident, restriction, and use
not in accordance with manufacturer’s instructions or which will have been altered or repaired by persons other than the
authorized agent or employees of the manufacturer.
DISCLAIMER
The provisions of the paragraph “Warranty” are the sole obligations of the manufacturer and exclude all other warranties of
merchantability, expressed or implied. Further, there are no warranties which extend beyond the above warranty.
LIMITATION OF LIABILITY
In the event of any claim or breach of any obligations of manufacturer under any order, whether expressed or implied, and
particularly in the event of any claim or a breach of the warranty or warranties contained in the paragraph “Warranty” or of
any other warranties, expressed or implied which might, despite the paragraph entitled “Disclaimer,” be determined to be
incorporated in any order, the company shall under no circumstances be liable for any consequential or special damages,
either in law or in equity, or for losses or expenses or claims for the same arising from the use of, or inability to use, the
products of the manufacturer for any purpose whatsoever.
WARNING: The entire machine safety system must be tested at the start of every shift. Machine testing should include:
(1) proper machine operation and stopping capability; and (2) verification of proper installation and settings of all point of
operation guards and devices before the operation is released for production.