AMETEK HPD Series - Manual (Page 26)

Installation and Configuration
Remote/Local Operation
24 Operating Manual for GPIB for XT/HPD Series Power Supply
Power On
Service
Request
(PON SRQ)
Setting the rear panel PON SRQ switch SW1-2 to open causes the power supply to
send a service request to the computer controller when the power supply is turned on
or when it re initializes after a momentary power interrupt. When a service request
is sent, the front panel SRQ LED will also turn on. You can clear the service request
and turn off the SRQ LED by performing a serial poll. See also “Command
Reference” on page 40 for information about the SRQ command.
Table 2.6 Enable Switch Selection
Rear Panel Switch SW1-2 PON SRQ State
Open PON SRQ Enabled
Closed PON SRQ Disabled