AMETEK PLA-PLW - Manual (Page 112)

PEL COMMANDS PLA & PLW COMMANDS PEL Syntax & Parameters PLA Syntax & Parameters
INP[?] INP[?]
INP[:STAT][?] INP[:STAT][?]
SHOR SHOR
INP:SHOR[:STAT][?] INP:SHOR[:STAT][?]
SET[?] SET[?]
VSET[?] VSET[?]
VOLT[:LEV][:IMM][?]
VOLT[:LEV][:IMM][?]
VOLT[:LEV]:TRIG[?] VOLT[:LEV]:TRIG[?]
ISET[?] ISET[?]
CURR[:LEV][:IMM][?]
CURR[:LEV][:IMM][?]
CURR[:LEV]:TRIG[?] CURR[:LEV]:TRIG[?]
RSET[?] RSET[?]
RES[:LEV][:IMM][?]
RES[:LEV][:IMM][?]
RES[:LEV]:TRIG[?] RES[:LEV]:TRIG[?]
PSET[?] PSET[?]
POW[:LEV][:IMM][?]
POW[:LEV][:IMM][?]
POW[:LEV]:TRIG[?] POW[:LEV]:TRIG[?]
TR[?] TR[?]
TLEV[?] TLEV[?]
VTR[?]
VTR[?]
VOLT:TLEV[?] VOLT:TLEV[?]
ITR[?] ITR[?]
CURR:TLEV[?] CURR:TLEV[?]
RTR[?] RTR[?]
RES:TLEV[?] RES:TLEV[?]
PTR[?] PTR[?]
POW:TLEV[?] POW:TLEV[?]
SLEW[?] SLEW[?] Check PEL Slew Rate
Specifications 1) PLA/PLW slew rate based on
Slew Rate Specifications
2) For PLA/PLW to PEL slew
rate conversion, use the following
conversion equation: [(Trans
Value - Main Value)/[Desired
Slew Time (ms)] (A/us)]
(Note: This command will change
both +/- Slew Rate Value)
VOLT:SLEW[?] VOLT:SLEW[?]
CURR:SLEW[?] CURR:SLEW[?]
RES:SLEW[?] RES:SLEW[?]
POW:SLEW[?] POW:SLEW[?]
DUTY[?] DUTY[?] PEL Duty Range: 2~98 PLA/PLW/LPL Duty Range
0~100
VOLT:DUTY[?] VOLT:DUTY[?]
CURR:DUTY[?] CURR:DUTY[?]
RES:DUTY[?] RES:DUTY[?]
POW:DUTY[?] POW:DUTY[?]
FREQ[?] FREQ[?] PEL Frequency Range: 0.1 ~ 20
Khz
LPL/PLW/PLA Frequency
Range: 0.1 ~ N Khz (N;
maximum range value will vary
by model)
VOLT:FREQ[?] VOLT:FREQ[?]
CURR:FREQ[?] CURR:FREQ[?]
PEL & PLA/PLW PROGRAMMING COMMAND COMPATIBILITY CHART
A-2