Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 108)

Functional Description
ATCA-8330 Installation and Use (6806800S82B) 108
DSPx_USER_HW_CONF[3:0] HW Strapping DSP position on Mezzanine set by
strapping resistors range 0 - 11
0000 = DSP0
0001 = DSP1
0010 = DSP2
0011 = DSP3
All others are reserved.
DSPx_USER_HW_CONF[7:4] Module_ID[3:0] Mezzanine card position derived from
Module_ID[3:0]
0000 = DIMM Module0
0001 = DIMM Module1
0010 = DIMM Module2
0011 = DIMM Module3
0100 = DIMM Module4
0101 = DIMM Module5
0110 = DIMM Module6
0111 = DIMM Module7
1000 = DIMM Module8
1001 = DIMM Module9
All others are reserved.
DSPx_USER_HW_CONF[13:8] HW Strapping Strapped by resistor to 1
DSPx_USER_HW_CONF[14] HW Strapping 0 = Unique factory-burned per-chip
MAC address (default)
1 = TFTP server with IP derived from
00:0C:90:02:<USER_HW_CONFIG>xx
DSPx_USER_HW_CONF[15] HW Strapping 0 = TFTP server at 192.168.1.200
(default)
1 = TFTP server with IP derived from
192.168.<USER_HW_CONFIG>xx
BOOT_MODE[3:0] HW Strapping Strapped by resistor to 0100 = BOOTP
on EMAC 2 on SERDES 2
Table 5-2 DSP Control Signals (continued)
Signal Group Controlled by Description