Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 80)

BIOS
ATCA-8330 Installation and Use (6806800S82B) 80
Procedure
To restore the BIOS default settings, proceed as follows:
1. Remove the blade from the system. See Installing and Removing the Blade on page 53 for
the exact procedure.
4.7 BIOS Setup Configuration
4.7.1 Main
Table 4-1 Main
Item Values Description
System Date [Thu 11/11/2010] Set the Date. Use Tab to switch between
Date elements
System Time [15:48:21] Set the Time. Use Tab to switch between
Time elements.
Table 4-2 Main -> Boot Configuration
Item Values Description
Front Panel Net Boot Enabled (Default),
Disabled Controls execution of the Option ROM for
the Front Panel Ethernet controller. Select
Enabled when Front Panel Boot is required.
Base Network Boot Enabled (Default),
Disabled Controls execution of the Option ROM for
both Base Network Ethernet controller.
Select Enabled when Base Network Boot is
required.
USB Legacy Enabled (Default),
Disabled Enables/Disables Legacy USB support for
USB mouse/keyboard and mass storage in
legacy operation systems like DOS.
Info scree timeout 2 (Default) Set the timout in seconds for <F2> prompt.