Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 200)

Supported IPMI Commands
ATCA-8330 Installation and Use (6806800S82B) 200
9.3.1 Set Serial Output Command
This command allows you to set the serial output source for a particular serial port connector.
Table 9-20 Set Serial Output Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
2 2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be
used.
3 MSB of Artesyn IANA Enterprise Number. A value of 00h shall be
used.
4 Serial connector type:
0 = Front panel connector
1 = Backplane panel connector
All other values are reserved.
5 Serial connector instance number. A sequential number starts from
zero.
6 Serial output selector:
0 = BIOS
2 = IPMC debug console
All other values are reserved.
Response Data 1 Completion Code
2 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be
used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h shall be
used.