Artesyn COMX-CORE Series Installation and Use (August 2014) - Manual (Page 47)

Hardware Preparation and Installation
COMX-CORE Series Installation and Use (6806800K11F) 47
Installing the COM Express Module on the Carrier Board
1. Line up the board-to-board connector of the COMX-CORE Series module with the
board-to-board connector of the carrier board.
2. Make sure that the interconnectors are properly aligned and that the seven
standoffs have contact with the top of the carrier board.
3. Turn over the COMX-CORE Series module and the carrier board.
4. From the backside of the carrier board, locate the screw holes.
5. Use the screws to fasten the COMX-CORE Series module assembly to the carrier
board.
Removing the COM Express Module from the Carrier Board
1. Turn over the COMX-CORE Series module and the carrier board.
2. From the backside of the carrier board, locate the seven screws that connect the
COMX-CORE Series module to the carrier board.
3. Loosen and remove the screws.
4. While holding the edges, pull the COMX-CORE Series module from the carrier
board.