Artesyn COMX-CORE Series Installation and Use (August 2014) - Manual (Page 98)

BIOS
COMX-CORE Series Installation and Use (6806800K11F) 98
State After G3 Specify what state to go to when power is re-applied after a power
failure (G3 state). Options: S0 State, S5 State.
Default is S5 State.
Table 5-34 USB Configuration
Field Description
EHCI1 Controls the USB EHCI (USB2.0) functions
One EHCI controller must always be enabled. EHCI1 is in charge of six
USB ports (J14, J15, P2).
EHCI2 Controls the USB EHCI (USB2.0) functions
One EHCI controller must always be enabled. EHCI2 is in charge of 3
USB ports (P1, P39, P3).
Table 5-35 SATA Configuration
Field Description
SATA Controller(s) Enable/Disable SATA Device.
Default is Enabled.
COMX-CORE-510/710/750 supports SATA 1,2,3,4
COMX-CORE -312/512 supports SATA 1,2,5,6
SATA Mode Selection Determines how SATA Controller(s) operate.
Default is IDE.
Software Feature Mask Configuration will be shown as well. Refer to
Table 5-36
Serial ATA Port1/2/3/4 SATA Port1/2/3/4 State
Table 5-36 Software Feature Mask Configuration
Field Description
RAID0 Enable/Disable RAID0 feature
RAID1 Enable/Disable RAID1 feature
Table 5-33 IbexPeak Options (continued)
Field Description