Avery Dennison Monarch 928 Tag Tray - Manual

T A G T R A Y I N S T R U C T I O N S
Use the Monarch  927 Tag Tray to catch tags as they exit
from the knife. The tag tray does not stack tags in order. If
you need a stacker, the Monarch
 928 Stacker is
available. Contact your Monarch Representative for details.
When using the tray, make sure you cut tags after each
batch or after the last tag in the last batch. Refer to the
optional Packet Reference Manual for more information
about setting the cut options. Information in this document
supercedes information in previous versions. Check our
Web site (
www.monarch.com ) for the latest documentation
and release information.
Note: There may be one or two tags left between the
printhead and the knife, because the knife is two-
and-a-half inches away from the printhead.
I n s t a l l i n g t h e T r a y
1. Remove two screws from the knife’s cover.
2. Attach the metal plate to the front of the knife cover
using the two Phillips screws provided.
Attach Screw s Here
Metal Plate
Monarch , 927, and 928 are trademarks of Avery Dennison Retail Information Services LLC.
Avery Dennison  is a trademark of Avery Dennison Corporation.
TC0927ATOI Rev. BE 11/09 1998 Avery Dennison Corp. All rights reserved.