Avery Dennison Monarch 9906 Internal Liner Take-Up - Manual

O P E R A T I N G I N S T R U C T I O N S
These instructions are for the Monarch® 9906 printer using the internal liner take-up option.
I n t e r n a l L i n e r T a k e - U p
Internal liner take-up collects the liner on a take-up reel located inside the printer’s cover. This
feature must be used with peel mode. Refer to the 9906 Operator’s Handbook for additional
printer information.
1. Open the cover.
2. Unlock the printhead and lift the printhead
assembly until it locks into place.
3. Open the printer’s exit cover.
4. Remove the labels from the first 18 inches of the
liner.
5. Remove the liner take-up bail.
6. Feed the liner over the peel bar and under the
peel roller.
Monarch
 is a registered trademark of Avery Dennison Corporation
TC9906LTOI Rev. AB 4/13 2010 Avery Dennison Corp. All rights reserved.
P e el Ba r
7. Wrap the liner around the liner take-up core in a
counter-clockwise direction.
P e el R ol le r
L i n er T ak e - up C o r e
L i n er T ak e - up B ai l
L i n er
L i n er