Avery Dennison Platinum 6039 Screen Protector - Manual

TC6039SPOI Rev. AD 5/09 ©2005 Avery Dennison Corp.
All Rights Reserved.
U S I N G T H E
S C R E E N P R O T E C T O R
I n s t a l l i n g t h e S c r e e n P r o t e c t o r
1. Remove the mask film from the screen protector.
Place a piece of adhesive tape on one corner of the
film and quickly pull back.
2. Install the masked side facing the printer’s touch
screen display. The unmasked side is the writing
surface.
3. Clean both sides of the screen protector and the
printer display with a soft cloth moistened slightly
with distilled water and allow to dry. Do not use
household cleaners to clean the printer.
Warning: Failure to clean the display and screen
protector may scratch or damage your
printer display.
4. Slide the edge of the screen
protector between the printer and
the display.
5. Bow the screen protector slightly
and slide the other edge of the
screen protector between the
printer and display on the opposite
side.
6. Use your thumbs to gently guide the
screen protector into place at the
bottom of the printer display until it
covers the display and lays flat.
Note: Be careful not to bend or
crease the screen protector.