Basler Electric BE1-700 Modbus Protocol - Manual (Page 19)

9376700991 Rev D BE1-700 Modbus™ Protocol 1-9
4) Testing your network can be done from your computer’s DOS command shell. To open a DOS
command shell in Windows®, select the Start RUN Open: cmd. (Figure 1-11).
Figure 1-11. DOS Command Shell
5) Example
WITH a DHCP server
In the DOS command shell type ipconfig to see the available networks ( Figure 1-11 ):
Figure 1-12. DOS Command Example with DHCP Server
6) Example WITHOUT a DHCP server
In the DOS command shell type ipconfig to see the available networks ( Figure 1-13 ):
Figure 1-13. DOS Command Example without DHCP Server
After a few minutes (when a DHCP server is not detected) a default IP address with the format
169.254.xxx.xxx address will be reported. (Figure 1-14)