Beisler 1281-4 - Manual (Page 17)

1-15
5.4.1 Components of the operation device
The components of the operation device provide the following functions:
Display (1): all information required for the operation of
the machine are imaged here.
Cursor keys (2): use them to move the cursor and mark all
required commands and options.
Special key (3): press this key if several information is
required for an adjustment.
Minus/Plus keys (4): use them to enable/disable functions, redu-
ce/increase numeric values and select
programs.
Key M1 (5): press this key to set back the mouse.
Key M2 (5): press this key to trigger the stacking.
Key M3 (5): press this key to swing the pulling device up.
5.4.2 Explanation of the display
After switching on with the main switch, the program will be displayed which
had been used previously. The machine is ready for sewing instantly:
PROG. HAUPTNAHT
001
STEP
01
10
A
a: 5000
A: 25
STOP
Fn
P1
P2
As a factory setting, several sewing programs are contained in the buffer of
the machine, which can be selected using the Plus/Minus keys. The available
programs are listed further below.