Beisler 1281-4 - Manual (Page 35)

2-9
3.4.3 Foot pedal
Hint
The settings contained here are set perfectly as a factory setting and may not
be modified.
3.4.4 Cover Page
P1
P2
SETUP
-02
P1
P2
P TXT
5:P5
6:P6
7:P7
8:P8
Cover N:1
P TXT
1:P1 Puller 44
2:P2 Kettuptran 30
3:P3 Staplertran 1
4:P4
Vorrichtung
Here you can enable parameters. Enabled parameters will be listed on the
cover page 001 and can be modified there, without accessing the machine
setup.
Move the cursor to the parameter to be enabled or disabled. Press the Plus
key. An enabled parameter is indicated by a triangle displayed to the left of it.
The cover page icon on setup page -02 must be enabled to allow the use of
the cover page. If it is enabled, the cover page will be displayed before
program page PROG 001:
POS
001
COVER
0
P1 PULLER:
P2 KETTUPTRANS:
P3 STAPLERTRANS: 44
30
1
a: 5000
STEP: 1
PRG: 1
Open the page COVER 001, position the cursor on the desired parameter
and modify the setting by pressing the Plus or Minus key.
P1 PULLER: this parameter is the speed of the pulling device transportati-
on during the sewing;
P2 KETTUPTRANS: here you can set the speed of the smooth-out device
for cutting the chain; this speed should be adjusted in a way that the
thread chain can be sucked into the kett-up safely;
P3 STAPLERTRANS: here you can set the stacking position of the fabrics
after the cutting of the chain.