Beisler 1281-4 - Manual (Page 38)

2-12
All values must be set like shown in the drawing.
JS jog speed: this function is not used at this machine;
KJ speed factor in POS mode: speed for the smooth-out distance;
KP speed factor in puller mode (1 ... 15): speed factor for the synchronous
operation (1 ... 7 = half step mode; 8 ... 15 = full step mode);
KA acceleration curve of the step motor;
IL holding voltage in home position (1 ... 15): this should reduced to a
minimum to avoid over heating;
IH working voltage (1 ... 15): here you have to consider the
manufacturer’s information; if the working voltage is set too high, the
motors will be destroyed.
ATTENTION
Damage to the motors due to inadequate settings! Before you modify one of
the values shown here (especially value IH), you should contact the Beisler
service staff.
3.6 Setup page -10
M8 M7 M6 M5 M4 M3 M2 M1
F12 F11
F10 F9 F8 F7 F6 F5 F4 F3 F2 F1
SETUP
-10
All inputs (F1 ... F12) and outputs (M1 ... M8) are displayed on this page. For
diabled inputs/outputs, the respective icon is crossed out.
At this machine, the output F1, and the inputs M3 ... M6 and M8 must be
disabled. Position the cursor on the icon of an input/output and press the
Plus/Minus key to alter the setting.
The outputs are valves and occupied as follows:
Valve description Output connector
F1 Y1 Lift sewing foot pin 1
F2 Y2 Table blowing pin 3
F2 Y13 Waste evacuation (option with stitch type 515) pin 3
F2 Y16 Tension release for needle thread (option stitch type 515) pin 3
F3 Y3 Contour guiding up and blowing in the contour guiding pin 5
F4 Y4 Contour guiding forward/backward pin 7
F5 Y5 Kett-up pin 9
F6 Y6 Smooth-out device up/down pin 11
F7 Y7 Stacker impulse pin 13
F8 Y8 Transportation unit up/down pin 15
F9 Y9 Top feed adjustment pin 17
F10 Y10 Bottom feed adjustment pin 18
F11 Y11 Mouse backward pin 14
F12 Y14 Drive contour guiding laterally (see below) pin 14
Y15 Stacker up/down (option) pin 12 +24 V pin 19 -24 V