Beisler 1281-4 - Manual (Page 45)

2-19
3. Position the cursor on the „W“ in the upper right corner of the display and
push the storage module into the slot at the operation device.
4. Press the Plus key to write the selected sewing program on the storage
module.
4.4 Read a single sewing program into the machine control
1. Select the program memory location, where the program shall be read to.
2. Press the Special key. The same will be displayed like shown in section
4.3.
3. Position the cursor on the letters „PRG“ and press the Plus key to delete
the data contained on the selected memory location.
4. An inquiry will be displayed, where you have to confirm the deletion by
pressing the Plus key. The deletion cannot be undone.
5. Plug the storage module into the slot at the operation device.
6. Position the cursor on the letter „R“.
7. Press the Plus key to read the program from the storage module into the
machine control.
8. Press the Special key to leave the page. The machine is ready to use.
Hint
You can use this procedure to copy a sewing program from one memory
location to another.