Belshaw Adamatic Mark VI Donut Robot - Manual (Page 15)

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark VI OM MN-1032EN 7
c. Lift the conveyor assembly from the
conveyor locating pin and pull it away
from the heater head to disengage the
main drive shaft coupling from the
conveyor drive coupling.
d. Lift the outfeed end of the conveyor.
Slide one piece of wood under the
conveyor and lay it across the top of the
kettle. Lift the other end of the conveyor
and do the same with the other piece of
wood. The conveyor will now be resting
on the two pieces of wood. Let the
shortening drain off of the conveyor and
into the kettle. See Figure 2-2.
Figure 2-2. Draining the Shortening off of
the Conveyor.
6. If you want to clean the turner assembly,
remove and clean it as follows:
a. Move the flight bars of the conveyor
until the turner is in the middle of a flight
pocket.
b. Swing the turner cam weight up.
c. Lift up and pull out on the turner cam
assembly. See Figure 2-3.
d. Lift out the turner assembly. See Figure
2-4.
e. Wash the turner cam assembly and turner
assembly using mild detergent and warm
water.
Figure 2-3. Removing the Turner Cam
Assembly.
Figure 2-4. Removing the Turner Assembly.
f. Rinse the turner cam assembly and
turner assembly in clear water.
g. Dry these parts thoroughly.