Belshaw Adamatic Mark VI Donut Robot - Manual (Page 38)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1033EN Donut Robot Mark VI TS
Figure 1-2. Donut Robot Mark VI, Set up for Producing Cake Donuts.
Unpacking the Fryer
To unpack the Donut Robot
®
Mark VI and
transport it to the work station:
1. Remove the foam and other packing
materials from the two boxes.
2. Carry the hopper, plunger, and swing
column to the work station.
3. Coil the cutter head power cord and carry
the cutter head to the work station.
4. Carry the conveyor assembly to the work
station.
5. Remove the clevis pins that hold the heater
head in place, and lift the heater head out of
the fryer.
6. Coil the power cord and carry the heater
head to the work station.
7. Move the fryer case and kettle to the work
station.
Initial Cleaning
Thoroughly clean your Donut Robot Mark VI
before using it. Remove all packing materials.
Refer to Section 3, “Cleaning.”
WARNING
To avoid electrocuting yourself or
damaging the machine, never allow any
kind of liquid to enter the cutter head or
heater head assemblies.
swing connecting rod fryer
swing
column
splash guard heater head
plunger
hopper
cutter head
conveyor
bearing strut