Belshaw Adamatic Mark VI Donut Robot - Manual (Page 18)

Belshaw Bros., Inc.
• www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
10 MN-1032EN Donut Robot Mark VI OM
5. Remove the cleaning solution from the fryer
kettle. To do this, place a large metal bucket
underneath the drain valve. Slowly open the
drain valve and allow the cleaning solution
to drain into the bucket. If the bucket
becomes full, close the drain valve and
replace the bucket. Continue draining into
another bucket.
WARNING
Do not use plastic buckets. If the cleaning
solution is not cool enough, the buckets will
melt; possibly causing burns, and causing
cleaning solution to get on the floor.
WARNING
Do not allow the cleaning solution to
overflow the buckets. Cleaning solution
will get on the floor, and if the solution is
not cool enough, you may be burned.
WARNING
Thoroughly clean and dry the floor if
cleaning solution is spilled. Liquid on the
floor can cause serious injury or loss of life.
6. Remove the conveyor and tilt the heater
head back as you did before.
7. Lift the kettle out of the fryer case.
8. Rinse the kettle thoroughly and dry it on the
outside.
9. Install the kettle, tilt the heater head
assembly down, and install the conveyor
assembly as before.
10. Close the drain valve.
Rinsing
1. Pour clean water into the kettle, up to the
normal level of the shortening.
2. Connect the machine to the power source.
Heat the water to 200
°F/93°C.
3. Run the conveyor for 5-10 minutes.
4. Turn off the heater and disconnect the
machine from the power source. Allow the
water to cool to 100
°F/38°C.
5. Remove the water from the fryer kettle by
placing a large metal bucket underneath the
drain valve. Slowly open the drain valve
and allow the water to drain into the bucket.
If the bucket becomes full, close the drain
valve and replace the bucket. Continue
draining into another bucket.
WARNING
Do not use plastic buckets. If the water is
not cool enough, the buckets will melt;
possibly causing you to be burned, and
causing water to get on the floor.
WARNING
Do not allow the water to overflow the
buckets. Water may spill, and if the water
is not cool enough, you may be burned.
WARNING
Thoroughly clean and dry the floor if water
is spilled. Water on the floor can cause
serious injury or loss of life.
Drying
1. With the help of another person, lift the
conveyor assembly out of the fryer case.
Tilt the heater head assembly back.
2. Thoroughly dry all parts, including the
conveyor, the heating elements, the inside of
the kettle, and the drain assembly.