Belshaw Adamatic Mark VI Donut Robot - Manual (Page 41)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Donut Robot Mark VI TS MN-1033EN 5
Assembling the Cutter
Read this section only if you are preparing to
make cake donuts.
1. Set the cutter head assembly onto the swing
column. See Figure 1-7.
Figure 1-7. Mounting the Cutter Head
Assembly.
2. Mount the hopper by sliding the two
mounting studs on the hopper arch into the
notches on the bearing strut. Secure the
hopper with the thumb nuts. See Figure 1-8.
Figure 1-8. Mounting the Hopper.
3. Install the plunger as follows:
a. Lift the plunger connecting rod assembly
up and out of the way.
b. Put the narrow part of the plunger’s
center rod through the slot in the center
of the hopper arch.
c. Lower the plunger until the wider part at
the top of the center rod enters the round
opening in the hopper arch and the
plunger’s piston just enters the hopper
cylinder.
d. Lower the connecting rod assembly and
insert the pin on the rod into the hole
near the top of the center rod. See
Figure 1-9.