Beurer BM 75 - Manual (Page 23)

23
Dat
e
The day flashes on the display.
• Choose the desired day with the M1/M2
memory buttons and confirm with the
Start/stop button .
If the hour format is set as 12h, the day/month dis-
play sequence is reversed.
Time
The hour flashes on the display.
• Choose the desired hour with the M1/
M2 memory buttons and confirm with the
Start/stop button .
The minute flashes on the display.
• Choose the desired minute with the M1/
M2 memory buttons and confirm with the
Start/stop button .
Operation with the mains part
You can also operate this device with a mains part.
When doing so, there must not be any batteries in the battery
compartment. The mains part can be obtained from specialist
retailers or from the service address using order number 071.60.
• To prevent possible damage to the device, the blood pres-
sure monitor must only be used with the mains part de-
scribed here.
• Insert the mains part into the connection provided for this
purpose on the right-hand side of the blood pressure moni-
tor. The mains part must only be connected to the mains
voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measurements are retained.
5. Measuring blood pressure
Please ensure the device is at room temperature before meas-
uring.
The measurement can be performed on the left or right arm.
Positioning cuff
Fit the cuff round your bare left upper
arm. Blood circulation in the arm
should not be restricted by tight cloth-
ing or other objects.
The cuff should be placed on the upper
arm so that the lower edge is 2 to 3 cm
above the bend of the elbow and
above the artery. The tube should be in
line with the centre of the palm.
Now tighten the free end of the cuff,
but make sure that it is not too tight
around the arm and close the
hook-and-loop fastener. The cuff
should be fastened so that two fingers
fit under the cuff.