Beurer BM 75 - Manual (Page 27)

27
blood pressure measurements as having been taken when the
circulatory system had not been sufficiently rested.
In this case, nervousness or inner anxiety may be the cause and
this cannot be cured by brief periods of rest. Existing cardiac ar-
rhythmias may also prevent a stable blood pressure measurement.
A lack of resting blood pressure can have various causes, such
as physical or mental strain or distraction, speaking or experi-
encing cardiac arrhythmias during the measurement.
In an overwhelming number of cases, the HSD diagnosis will
give a very good guide as to whether the circulatory system
is rested when taking the measurement. Certain patients suf-
fering from cardiac arrhythmia or chronic mental conditions
can remain haemodynamically unstable in the long-term,
something which persists even after repeated periods of rest.
The accuracy of the resting blood pressure results is reduced
in these users. Like any medical measurement method, the
precision of the HSD diagnosis is limited and can lead to incor-
rect results in some cases. The blood pressure measurements
taken when the circulatory system was at rest represent par-
ticularly reliable results.
7. Displaying and deleting measurements
User memor
y
The results of every successful measurement are stored
together with the date and time. If there are more than 60
measurements, the oldest measurements are lost.
• To access memory recall mode, the blood pressure
monitor must first be started. To do this press the Start/
stop button .
• Within 3 seconds of the full-screen display appearing,
select the desired user memory ( ) with the M1 or
M2 memory button.
User memor
y – To view the measurements for user memory , press
the M1 memory button.
– To view the measurements for user memo-
ry , press the M2 memory button.
Your last measurement will appear on the
display.
Aver
age values
• Press the relevant memory button (M1 or M2).
If you have selected user memory1, the M1 memory
button must be pressed.
If you have selected user memory2, the M2 memory
button must be pressed.
A flashes on the display.
The average value of all saved measured
values in this user memory is displayed.
• Press the relevant memory button (M1 or M2).
AM flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morn-
ing: 5.00 a.m. – 9.00 a.m.).
• Press the relevant memory button (M1 or M2).
PM flashes on the display.
The average value of the evening measure-
ments for the last 7 days is displayed (even-
ing: 6.00 p.m. – 08.00 p.m.).