Beurer BG 64 - Manual (Page 24)

24
15. What if there are problems?
If the scale detects and error when measuring, the following is displayed.
Display Cause Remedy
0_Ld The maximum load capacity of 150 kg
was exceeded.
Do not load the unit with over 150 kg.
Lo The batteries are almost empty. Replace the batteries (see page 16 and page
23).
Err The electrical resistance between the
electrodes and the sole of your foot is too
high (e.g. if you have tough calluses).
Repeat the measurement barefoot. If
necessary,moisten the soles of your feet slightly.
If necessary, remove the calluses from the soles
of your feet.
The fat percentage is outside the measu-
rable range (less than 5% or greater than
50%).
Repeat the measurement barefoot or, if neces-
sary, moisten the soles of your feet slightly.
The water percentage is outside the
measurable range (less than 36% or gre-
ater than 70%).
Repeat the measurement barefoot or, if neces-
sary, moisten the soles of your feet slightly.
The muscle and bone percentages are
outside the measurable range (age and
gender related).
Repeat the measurement barefoot or, if neces-
sary, moisten the soles of your feet slightly.
Full Data 30 measurements have been saved. Transfer the measurements to your PC.
No display The batteries in the control unit are com-
pletely empty.
Replace the batteries (see page 16).
The batteries in the control unit are not
inserted correctly.
Check to ensure that the polarity is correct (see
page 16)
No measurement possible
Possible errors Remedy
The scale was not activated before you stood on
it. If you step on the scale before “0.0 KG” is dis-
played, the scale will not work correctly.
Activate the scale correctly (wait for “0.0 KG”) and re-
peat the measurement. Switch on the control unit first
before the measurement. If necessary, wait 30 se-
conds, then repeat the measurement.
Cordless connection between scale and control
unit is interrupted.
Briefly remove, then reinsert the batteries of the sca-
le and the control unit; the scale sends an audible si-
gnal when you insert the batteries. Maintain a larger
distance from the following electromagnetic sources:
high-voltage pylons, television or wireless computer
systems, fitness equipment, mobile phones, weather
stations.
The control unit is too far away from the scale. Reduce the distance between the scale and control
unit; maximum distance is 2 metres.
The batteries in the scale are empty. Replace the batteries (see page 16).