D-Link DIR-68 User Manual

Page 53

Advertising

Section - Configuration

This Wizard helps you add wireless devices to the wireless network.

The wizard will either display the wireless network settings to guide you through manual configuration, prompt you to enter the PIN for the

device, or ask you to press the configuration button on the device. If the device supports Wi-Fi Protected Setup and has a configuration

button, you can add it to the network by pressing the configuration button on the device and then the on the router within 60 seconds. The

status LED on the router will flash three times if the device has been successfully added to the network.

There are several ways to add a wireless device to your network. A “registrar” controls access to the wireless network. A registrar only

allows devices onto the wireless network if you have entered the PIN, or pressed a special Wi-Fi Protected Setup button on the device. The

router acts as a registrar for the network, although other devices may act as a registrar as well.

Start the wizard.

Add Wireless

Station:

Add Wireless

Device Wizard:

Advertising