D-Link DIR-68 - Manual (Page 75)

75 D-Link DIR-68 User Manual
Section 4 - Security
Configure WPA-Personal (PSK)
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless
connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.
1..Log into the web-based configuration by opening a web browser and entering the IP address of the router (19.168.0.1). Click
on.Setup.and then click.Wireless.Settings on the left side.
. Next to Security Mode, select WPA-Personal.
. Next to WPA Mode, select Auto, WPA2.Only, or.WPA.Only. Use Auto
if you have wireless clients using both WPA and WPA.
4. Next to Cypher Type, select TKIP.and.AES, TKIP, or AES.
5. Next to Group Key Update Interval, enter the amount of time before
the group key used for broadcast and multicast data is changed (600
is default).
6. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a pass-phrase in ASCII format at both ends of the
wireless connection. The pass-phrase must be between 8-6 characters.
7. Click Save.Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose connectivity until
you enable WPA-PSK on your adapter and enter the same passphrase as you did on the router.