Comtech EF Data CME-5200 Manual - Manual (Page 18)

CME-5200 Digicast Media Router ASI Receiver Revision A
Installation & Initial Configuration MN/MRASIRCDC.IOM
• Contact
Comtech EF Data Customer Support if the shipment is:
! Incomplete
! Physically damaged
! Inoperable
2.3 Installation
The ASI-R is designed for ease of installation and configuration. Once the unit has
been removed from the packing container, please follow these instructions:
Step Procedure
1 Place the ASI-R on a flat surface with free-air flow where the LEDs can be
clearly observed with unrestricted access to the rear panel of the unit.
2 Connect the DC power connection to the connection labeled PWR on the
back of the unit and tighten the restraining nut to ensure secure operation.
3 Connect an RJ-45 Ethernet cable (patch cord) to the port labeled
ETHERNET. This cable should be connected to an Ethernet concentrator
(hub) or switch.
4 Connect a terminal cable (supplied) to the port labeled TERM. This cable
should be connected to a PC’s serial port (DB-9) to initially configure the
ASI-R.
5 Connect the AC power cord between a standard wall outlet and the power
supply. The blue LED will illuminate.
6
IMPORTANT
It is recommend that the ASI cable NOT be connected until the
unit has been completely configured.
Upon startup, the following LEDs will illuminate on the ASI-R front panel:
LED Function Label Description
Blue POWER LED illuminates if power is properly applied
Red ALARM
LED may illuminate since the unit is not yet
configured
Green M-ACT LED illuminates if MPE data is present
Green E-ACT LED flashes if there is Ethernet traffic/activity
7
Green E-LINK
LED illuminates if the Ethernet connection to
the Hub/Switch is operational
2-2