Comtech EF Data CME-5200 Manual - Manual (Page 29)

CME-5200 Digicast Media Router ASI Receiver Revision A
Device Management via User Interfaces MN/MRASIRCDC.IOM
4.2.5 PID Configuration
Figure 4-7. PID Configuration page
Packet Size
Determines the packet size of the incoming transport streams. Two packet sizes
are support 188 or 204. For 204-byte packets, the trailing 16 bytes are discarded.
PID
The ASI-R supports up to 64 PIDs. All PIDs are entered in four (4) character
hexadecimal format. For example, PID 25 would be entered as PID 0025, PID
200 would be entered as 0200 and PID 1353 would be entered as 1353. All
inactive PIDs should be set to a value of 0x1FFF (Not Defined).
Mode
The ASI-R supports both MPE decoding to IP and MPEG Transport Stream
(MPEGTS) over IP. The user must select the mode of operation for the desired PID.
IP (DVB-TS)
The IP address configured to send the MPEG TS over IP. The address may be
either Unicast or Multicast.
Port (DVB-TS)
The port number configured to send the MPEG TS over IP. The port setting
should be a value greater than 1024.
4-7