Comtech EF Data CME-5200 Manual - Manual (Page 28)

CME-5200 Digicast Media Router ASI Receiver Revision A
Device Management via User Interfaces MN/MRASIRCDC.IOM
4.2.4 Unicast Routing Configuration
Figure 4-6. Unicast Routing Configuration page
Allow Unicast
Select the Boolean if Unicast routing is to be supported. If the Boolean is not
selected, only Multicast IP support will be provided.
Route unknown to default gateway
If Unicast routing support is enabled, for IP packets that are received and are not
destined to the local subnet, all non-local Unicast packets are directed to the
default gateway for routing.
Filter on TSD MAC
This Boolean must be enabled if Unicast routing support is enabled, and the IP
Encapsulator on the head-end is configured for Unicast routes with configured
MAC addresses for each Transport Stream Demultiplexer (TSD).
TSD MAC
If the Filter on TSD MAC Boolean is enabled, this field is the MAC address used
for routing incoming MPE packets carrying Unicast. The configured MAC
address must match the incoming MAC address in the MPE packet. If the MAC
addresses do not match, the packet will be silently discarded.
VLAN
VLAN is supported on the ASI-R. Packets that are received on the ASI interface
as 802.1Q are routed to the Ethernet with the VLAN tags intact. The valid
ranges of the VLAN ID are 0 to 4095.
4-6