Dataprobe iBoot-G2 Operation Manual - Manual (Page 23)

V140506E iBoot-G2+ Page 23
8. iBoot Cloud Service
– BETA
iBoot Cloud Service (iBCS) allows customers with iBoot to access and control multiple iBoots in multiple
locations from a single portal with a single sign-on.
iBCS will not only make using iBoots easier, by consolidating all units into one sign-on and interface, it will also
enhance the number of situations where iBoot can be deployed.

Customers with Dynamic IP addressing will always be able to access their iBoot from any location.

Customers that do not allow in-bound connections can access their iBoots.

Service providers can manage multiple customer accounts with diverse security configurations
iBoot Cloud service is currently in development and is made available to our current users free of charge.
Please note that as at this beta stage, service interruptions may occur or new versions of the iBoot firmware
may be made available and necessary to keep current with the cloud development. The full Terms of Service
of the iBoot Cloud Service is
available here .
While the Cloud Service is in Beta stage, the firmware in the iBoot is fully tested and released by Dataprobe. If
you do not enable the cloud capabilities of the iBoot, you can expect continuous and dependable operation.
8.1. iBoot Cloud Users Forum
Dataprobe has established a special users’ forum for iBoot Cloud Service Beta. Please use this forum to post
any questions, comments and ideas about the iBoot Cloud Service. Registration is required to post to the
forum. Find the iBoot Cloud Users Forum
here .
8.2. iBCS Setup & Operation
Use of the iBoot Cloud Services requires the iBoot to be configured to access the Internet. Please review the
installation and configuration procedures to insure proper setup.
a. Establish Account with iBoot Cloud Server

Visit http://iboot.co from your browser

Click on Register

Complete the information