Dataprobe iBoot-G2 Operation Manual - Manual (Page 32)

V140506E iBoot-G2+ Page 32
Event Commands
These commands are only available to the
administrator.
get events
This command displays all scheduled events as shown
below. Example:
Date Time Repeat Action Outlet
1. 12/17/2012 16:30 every 0 Day(s) Off Main Run
2. 12/18/2012 04:00 every 1 Day(s) Cycle Exp1 Run
3. 12/17/2012 14:45 every 0 Day(s) On Main Hold
4. every 0 Day(s) On Main Run
5. every 0 Day(s) On Main Run
6. every 0 Day(s) On Main Run
7. every 0 Day(s) On Main Run
8. every 0 Day(s) On Main Run
set time server <dotted decimal> This command is used to set the IP Address of a
network time server. 69.90.182.55
set timezone <-12 – 12> This command sets the time zone offset for the iBoot
location. -5
set time enable <yes | no> This command enables or disables the use of the time
server and scheduled events.
Note: When Adding new events through the CLI. Set
this to no to prevent unintended power switching
No
get time Displays the current time and time server (when
enabled)
Current Time: 16:10:41 01/27/2010
Server: 64.90.182.55
Time Zone: -4
set event <1-8> <run | hold> This command is used to all the event to run, or put the
event on hold run
set event <1-8> date <mm/dd/yyyy>
This command is used to set the scheduled action’s
start date.
set event <1-8> time <hh:mm> This command is used to set the time the scheduled
action will occur in 24 hour format.
set event <1-8> repeat < minute | hour |
day> This command is used to set the increments for
repeating scheduled actions
set event <1-8> mult <0-999> This command sets how often the event will repeat, the
number of increments (as set by the command above)
before the next event.
set event <1-8> action <on | off | cycle > This command is used to set the scheduled action.
del event <1-8> This command deletes the scheduled action.