Dataprobe iBoot-G2 Operation Manual - Manual (Page 27)

V140506E iBoot-G2+ Page 27
Device Commands Set commands are available to the administrator only
set location <20 char. max>
get location This command is used to set the iBoot- G2’s location ID.
Get returns the current setting
New Boot
set cycle <1-999>
get cycle This command sets the cycle time in seconds
Get returns the current setting 5
set delay <0-999>
get delay This command sets the delay time in seconds
Get returns the current setting 1
set timeout <0-99>
get timeout This command sets the auto logout time in minutes
Get returns the current setting 2
set <main |exp1 | exp2> initial state <on |
off | last>
get initial state This command sets the initial state of the outlet when the
iBoot-G2 is initially powered up Last
set upgrade enable <yes | no> Enables or disables the ability to upload new firmware to
the iBoot-G2. no
login Prompts for admin credentials when logged in as user
logout Terminates the session
reboot This command reboots the iBoot-G2.
Graceful Shutdown Commands Set commands are available to the administrator only
Get gsd This command returns all the current settings for
Graceful Shutdown
set gsd <main | exp1 | exp2> enabled
<yes | no> This command enables or disables the shutdown delay
process. no
set gsd <main | exp1 | exp2> ipaddress
<dotted decimal> This command is used to set IP address of the target
system for graceful shutdown.
set gsd <main | exp1 | exp2> username
<20 char. max> This command sets username of the target system
set gsd <main | exp1 | exp2> password
<20 char. max> This command sets the password of the target system
set gsd <main | exp1 | exp2>
shutdowndelay <0-999> This command sets the shutdown delay in seconds
set gsd <main | exp1 | exp2> rebootdelay
<0-999> This command sets the reboot delay in seconds