Dataprobe iBoot-G2 Operation Manual - Manual (Page 29)

V140506E iBoot-G2+ Page 29
Network Commands
All set commands require a reboot before they take effect. These
commands are only available to the administrator.
get network
This command will return all the network settings as
shown below:
Mode: Static
IP Addres: 192.168.1.190
Subnet: 255.255.255.0
Gateway: 192.168.1.1
HTTP Port: 80
Linkback URL: 192.168.1.190
Telnet Port: 23
Heartbeat Port: 9100
DxP Port: 9100
DxP Control: Enabled
DxP Query: Enabled
Timeout: 22
set ipmode <static | dhcp> This command sets the IP Address setting mode. Static
mode locks the address as set, dhcp mode allows DHCP
server to assign address.
set ipaddress <dotted decimal>
This command is used to set the iBoot- G2’s ip address. 192.168.1.254
set subnet <dotted decimal>
This command is used to set the iBoot- G2’s subnet
mask.
255.255.255.0
set gateway <dotted decimal> This command is used to set the Gateway 192.168.1.1
set http port <0-65535> This command sets the port that the iBoot- G2’s web
server listens for incoming connections on. When set to
0 the web server is disabled.
80
set telnet port <0-65535>
This command sets the port that the iBoot- G2’s Telnet
server listens for incoming connections on. When set to
0 the Telnet server is disabled
23
set heartbeat port <0-65535> This command sets the port for the heartbeat protocol.
The heartbeat uses UDP and can be the same port
number as DxP, which is TCP 9100
set dxp port <0-65535>
This command sets the port that the iBoot- G2’s DxP
protocol service listens for incoming connections on.
When set to 0 the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The
CLI will protect against all 3 from being set to 0.
9100
set dxp control <enable/disable> This command allows the main and expansion ports to
be controlled using Dataprobe Exchange Protocol (DxP)
commands. Disabled
set dxp query <enabled/disable> This command allows the status of the main and
expansion ports to be queried using DxP Enabled
set linkback <url> This command sets the linkback URL displayed on the
logout page. 192.168.1.254
set time server <dotted decimal> This command is used to set the IP Address of a
network time server. 69.90.182.55
set timeout <0-999> This command sets the automatic network timeout in
minutes. 2