Dataprobe iBoot-G2 Operation Manual - Manual (Page 28)

V140506E iBoot-G2+ Page 28
Expansion Commands These commands are only available to the administrator.
get expansion This command displays the current settings of the
expansion ports. The response to this command is
determined by the expansion mode setting.
If iBoot-Exp or Power Control modes:
Link
Exp 1: Yes
Exp 2: No
If Independent I/O mode:
Output
Exp1:
IP Address: 192.168.1.202
Relay: 2
Exp2:
IP Address: 192.168.1.203
Relay: 3
set expansion mode <exp | io | power> This command sets the mode for the expansion ports to
iBoot-Expansion or External I/O or Power Control exp
set expansion <exp1 | exp2> link <yes
|no> This command sets the Exp1 or Exp2 to be linked to the
main outlet for simultaneous control. This command
takes effect only when expansion mode is iBoot-
Expansion. no
set expansion <exp1 | exp2> ipaddress
<dotted decimal> This command sets the IP address to send input status
information via DxP protocol to. This command takes
effect only when expansion mode is io.
set expansion <exp1 | exp2> relay <1-8> This command sets the DxP command relay number to
be controlled by input changes from Exp1 or Exp2. This
command takes effect only when expansion mode is io. Exp1: 2
Exp 2: 3
set <exp1|exp2> username <20 char> This command sets the DxP command username. This
command takes effect only when expansion mode is io.
set <exp1|exp2> password <20 char>
This command sets the DxP command password. This
command takes effect only when expansion mode is io.