DFI HU101 - Manual (Page 19)

www.dfi .com
19
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 1 12V (HU101) or 19~24V (HU103) DC-in jack or 4-pin power connector* (optional)
• 2 HDMI ports
• 2 RJ45 LAN ports
• 2 USB 2.0 ports
• 2 USB 3.0 ports
• 1 Mic-in jack
• 1 Line-out jack
12V DC-in (HU101)/19~24V DC-in (HU103)
DC-in
This jack provides maximum of 100W power (for HU101)/120W power (for HU103) and is con-
sidered a low power solution. Connect a DC power cord to this jack. We only provide 12V DC
output (for HU101)/19V DC output (for HU103) in the package contents. Using a voltage more
than the recommended range may fail to boot the system or cause damage to the system
board.
The DC-in jack on the system board co-lays with a 4-pin power connector (optional) as the
photo displayed below.
DC-in jack
4-pin power
USB 3.0
USB 2.0
DC-in
HDMI 1
HDMI 2
Mic-in
Line-out
LAN 2 LAN 1