DFI KB160 - Manual (Page 40)

www.dfi .com
40
Chapter 3 BIOS Setup
Chapter 3
Ipv4 PXE Support
When enabled, Ipv4 PXE boot supports. When disabled, Ipv4 PXE boot option will not
be created.
Ipv6 PXE Support
When enabled, Ipv6 PXE boot supports. When disabled, Ipv6 PXE boot option will not
be created.
PXE boot wait time
Enters the wait time to press ESC key to abort the PXE boot.
Intel(R) I210 Gigabit Network Connection - 00:01:29:53:...
This section is used to configure the parameters of Gigabit Ethernet device.
NIC Configuration
This field is used to configure the network device.
Blink LEDs
Blink LEDs for the specified duration (up to 15 seconds).
Link Status
This field indicates the link status of the network device.
Alternate MAC Address
Alternates assigned MAC address of Ethernet port.
Click to confi gure the
network device port.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Version 2.16.1240. Copyright (C) 2013 American Megatrends, Inc.
PORT CONFIGURATION MENU
 NIC Confi guration
Blink LEDs (range 0-15 seconds)
PORT CONFIGURATION INFORMATION
UEFI Driver:
Adapter PBA:
Chip Type:
PCI Device ID
PCI Bus: Device: Function:
Link Status
Factory MAC Address:
Alternate MAC Address:
Advanced
0
Intel(R) 1GbE DEV 5.1.00
001300-000
Intel i210
1533
2:0:0
[Disconnected]
00:01:29:53:86:9F
00:01:29:53:86:9F
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit