DR Power Tow-Behind 9.00 Commercial (May 2006 - July 2010) - Manual (Page 20)

16 DR ® COMMERCIAL LEAF and LAWN VACUUM
Collector Box Installation
The following procedure includes all of the steps necessary
for the installation of the Collector Box on the DR LEAF and
LAWN VACUUM.
Figure 9
Figure 10
Panels Inserted
in Slots
Figure 11
Pin in Hole
Latches
Wing Screw
4 places
Push Out
1. Place the projecting edges of the two (2) Side Panels
on top of the Trailer with the Side Support Plates in
the slots on the trailer as shown.
NOTE: The Side Support plates are loosely mounted to the
Side Panels to allow for easy alignment and
expansion of the plastic. Align the holes in the
projecting edges with the holes in the Trailer Frame.
Secure them at each end to the Trailer Frame with
the 5/16" x 2" Wing Screws. Install a Lock Washer
followed by a Flat Washer on each Wing Screw.
Insert the Wing Screws through the frame from the
outside (Figure 9).
2. Tip the Centrifugal Separator at a 45° angle and slide
it between the secured sides on the Trailer with the
hose protruding along the right side of the Trailer
pointing toward the front (Figure 10).
3. Place the left edge of the Centrifugal Separator on
top of the left Side Panel. (Figure 10).
Tip: You can accomplish this easier with two (2) people.
4. Lift the hose side of the Centrifugal Separator and
place it on top of the right Side Panel; align the holes
in the top edges of the Side Panels with the
protruding Pins from the Centrifugal Separator and
secure in place with the Flexible Latches (Figure 11).
Tip: Push out in the middle of the top of the Side Panel
to help seat the Pin in the hole in the middle of the
top edge of the Side Panel.