DR Power Hydraulic 20-Ton - Manual (Page 15)

DR  20-Ton WOOD SPLITTER Safety & Operating Instructions 11
Figure 3
6. Install the retaining nut by hand. To
tighten the nut, insert a screwdriver blade
into a slot on the nut and tap gently with a
hammer (Figure 3) until the nut is seated
firmly against the bearing. Use care not to
damage the axle threads. A slot in the nut
must be aligned with the cotter pin hole in
the axle. Either tighten slightly or loosen to
align a slot with the hole. Check to be sure
that the wheel spins freely.
7. Insert the cotter pin through the aligned
slot and the hole in the axle (Figure 4).
8. Bend the top of the cotter pin over to
retain it in the assembly (Figure 4). Tap the
hubcap into place on the wheel hub.
9. Repeat steps 5 through 8 for the second wheel.
10. Do not discard your pallet and packaging material until you are fully satisfied with
your machine.
Check the Tire Pressure
There should be 60 psi in each tire.
Slot
Figure 4
Cotter Pin
Bend over