DR Power Hydraulic 20-Ton - Manual (Page 31)

DR  20-Ton WOOD SPLITTER Safety & Operating Instructions 27
7. Fill the hydraulic tank with fresh fluid to about 1" from the top of the tank.
8. Insert a new filter element in the filler opening and replace the filler cap.
9. Start the splitter engine and operate the ram back and forth a couple of times to bleed
the air from the hydraulic system.
10. The pressure gauge should now indicate a pressure in the “green” area of the pressure
gauge dial (0-25 psi).
11. Recheck and adjust the hydraulic fluid level per step 7.
Figure 24
Drain Elbow
Pump Hose Clamp