DR Power Hydraulic 20-Ton - Manual (Page 17)

DR  20-Ton WOOD SPLITTER Safety & Operating Instructions 13
Figure 9
Figure 10
3. Hook the Lift Support Bracket
over the lower edge of the H-
beam frame on the Operator’s
side and insert the bracket's
threaded rod through the tab
that extends down from the
mounting plate (Figures 7 & 8).
Secure with a nut using a 9/16"
socket.
4. Bolt left end of the multi-position Lift Support into the bracket on the Lift Arm
Assembly's crosspiece using 5/16" bolts and
1/2" socket or wrench, making sure that the
slots in the Lift Support face down (Figure 9).
5. Attach the Lift Arm Assembly to the
Mounting Plate using two retaining pins and
spring clips (Figure 10).
6. Hold the Lift Support up between the arms of
the Lift Support Bracket and install a 5/16"
bolt through the lower set of holes in the
bracket below the right end of the Lift Support
and tighten with a 1/2" socket (Figure 9).
Log Lift Mounting Plate
Lift Support
Bracket
Figure 7
Lift Support
Lift Arm Assembly
Cross Piece
Slots facing down
5/16" Bolts and
Nuts here
Lift Support
Bracket
Lift Arm
Assembly
Retaining
Pins here
WARNING! Always remove the Log Lift before transporting the splitter and
never let anyone ride on the Log Lift.
Figure 8
Tab
Threaded Rod
Spring Clip
Spring
Clip
Mounting Plate