DR Power 9 HP (March 2004 - March 2010) - Manual (Page 4)

SAFETY WEAR
Never wear loose clothing or jewelry that can be caught by moving parts of your stump cutter and
pull you into it. Keep all clothing away from moving parts. Wear proper headgear to keep hair
away from moving parts.
Always wear safety glasses provided with your unit at all times while operating your stump
cutter. A chip could fly out and hit you in the eye. Be sure your glasses fit properly.
SAFETY OPERATING PROCEDURE
If it is necessary for any reason to inspect or repair any part of the machine, stop the machine, allow it to cool,
disconnect the spark plug wire from the spark plug and move it away from the spark plug before attempting
such inspection or repair. Whenever you operate your stump cutter, wearing safety glasses is required.
Before each use, check all three controls; brake, throttle, clutch, to be sure they are functioning properly.
The operation of any stump cutter can result in foreign objects being thrown into the eyes, which can result in
severe eye damage. Always wear the safety glasses provided with the stump cutter or eye shields before
chipping or while performing any adjustments or repairs.
OPERATE IN A SAFE ENVIRONMENT
Operate equipment only in daylight or in good artificial light.
Extreme care must be taken when operating your machine on a side hill. It could tip, or poor footing could
cause an accident. Do not operate the machine parallel to the hill. Always stand uphill from the stump.
A. Secure handle in front or rear position.
B. Do not use your machine on muddy or icy surfaces.
C. Never leave your machine unattended with the engine running.
Thoroughly inspect and clear work area of objects that might be picked up and thrown. Remove all stones,
sticks, wires, bones and other foreign objects. Beware of hidden objects located above or below ground, such
as electric wires, gas or water lines, and sprinkler systems. DO NOT BEGIN TO CHIP STUMPS unless you are
sure the area is clear.
1. Know how to turn the machine off.
2. HANDLE GASOLINE WITH CARE as it is an extremely flammable fuel.
3. Check the fuel before starting the engine. Do not fill the fuel tank indoors, while the engine is running, or
while the engine is still hot. Turn the unit off and let the engine cool for at least three minutes before
refueling. Fuel your stump cutter in a clean area to avoid getting dirt in the gas tank. Do not smoke while
refueling. Fuel tank cap must be secure at all times except during refueling. Avoid spilling gasoline or oil.
Wipe the unit clean of any spilled fuel or oil.
4. Store fuel and oil in approved containers, away from heat or open flame, and out of reach of children.
Leave 1/2-inch air space at top of fuel tank to allow for expansion of fuel.
REPAIR AND MAINTENANCE SAFETY
Never operate your stump cutter in poor mechanical condition. Periodically check that all nuts,
bolts, screws, and belts are tightened to specifications. Be sure all safety guards and shields are
in proper position. These safety devices are for your protection.
Be sure to read and follow engine owner’s manual for engine maintenance and repair.
BEFORE STARTING ENGINE, ALWAYS CHECK OIL LEVEL
4