DR Power 9 HP (March 2004 - March 2010) - Manual (Page 5)

SECTION II - ASSEMBLY INSTRUCTIONS
PACKAGE CONTENTS
SKID POLYBAG
STUMP GRINDER OWNER’S MANUAL
HANDLE ASSEMBLY ENGINE MANUAL
POLYBAG SAFETY GLASSES
ALLEN WRENCH
4 EA – CABLE TIES
STEP 1 - UNPACKING AND CHECKING CONTENTS
1. Remove all pieces from the skid.
2. Compare all items with the list above.
3. If any parts appear missing or damaged, contact Country Home Products at 1-800-376-9637.
4. Assembly should be done on a clean and level surface.
STEP 2 - INSTALLING HANDLE SUPPORT
1. Loosen and remove the two bolts mounting the handle support (item #23, pg. 15) to the bumper straps (item
#22, pg. 15).
2. Flip the handle support to the upright position with the six adjustment holes above the bumper straps.
3. Replace and tighten the bolts through the bumper straps to the handle support that were removed in step 1
STEP 3 - INSTALLING HANDLE ASSEMBLY
The handle assembly is packed with the cables attached, so be careful not to over extend the handle away from
the stump grinder and break them loose.
1. Remove bolt and nut (items #50 & #64, pg. 15) from the pivot pin weldment (item #13, pg. 15) and pull it out
of the pivot bracket.
2. Carefully pick up the handle assembly (item #14, pg. 15) and put it in place so that the bend is down and the
handle grips are at the cutter head end (rear position). NOTE: Care needs to be taken to prevent the
cables from being torn loose, dislodged, or pinched.
3. Insert pivot pin through the first hole on the handle mount plate (item #9, pg. 15), through the lower handle
tube, and into the other hole on the handle mount plate.
4. Secure the pivot pin with the hardware you removed in step 1.
5