Eizo DuraVision FDS1904 取扱説明書 - Manual (Page 30)

10
3.
Connect the monitor to a power supply.
There are two options for connecting the monitor to a power supply. Make the connection according
to the installation environment and conditions of use.
• Using the AC power connector
• Using the DC power terminal block
Attention
• Do not turn on the monitor or electrify connecting wires until connection to the power supply is complete.
●
Using the AC power connector
1. Connect the power cord to the AC power connector.
Securely fix the power plug.
2. Connect the power cord to the power outlet.
●
Using the DC power terminal block
1. Disconnect the terminal block.
DC power
terminal block
2. Connect the electrical wires to the terminal block.
Attention
• Use electrical wire of AWG 18 to 12 (0.8 to 3 mm 2 ).
1. Strip the insulation from the electrical wires (stripping length: 7±0.5 mm).
2. Add a ferrule to the end of each wire, if required.
Use ferrules manufactured by PHOENIX CONTACT.
Ferrule
7±0.5 mm