ESI ESP1010 - Manual (Page 19)

ESP1010
H·P: The signal from channel 1/2 can be sent to the headphone outputs.
MIX OUT: Send out the mixer signal to output 1/2 and/or the S/PDIF
output. Please refer to section 5 on page 20, for more information on the
Mixer Panel. You can send the mix to the headphones as well, when H P
is enabled.
S/PDIF PRO/CON: ESP1010 can transmit digital information in either of
two formats, Pro (professional / IEC60958 Type I) and Con (consumer /
IEC60958 Type II).
3) MASTER: You can adjust all input / output monitoring levels by clicking
and dragging the fader in the master control panel. Again the number on
the bottom shows you the relative monitoring level in dB. Clicking this
number enables you to mute the channel.
LINK: You can control volume of left and right channels independently by
deselecting this button.
4) S / R: You can configure the sampling rate in this panel.
Auto: Automatically sets the sampling rate to your audio file’s sampling
rate.
22~96: You can set the sampling rate manually from 22kHz to 96kHz.
5) MASTER CLOCK: Allows you to choose the digital clock source for
- 19 - 19