ESI ESP1010 - Manual (Page 26)

ESP1010
2. DirectWIRE Panel
Click on DirectWIRE on the ESP1010 panel. The DirectWIRE panel window as
shown below will appear.
The number along the row represents the number of the input or output port.
The columns represent inputs and outputs (on and off) of the respective drivers.
Patch the virtual cables from one point to another as you drag your mouse.
INPUT column is a new feature of DirectWIRE 3.0. It's used to route signals
from the card's hardware inputs. With ESP1010, from INPUT 1 to 8 are identical
to the each left and right channels of the analog input signal. And INPUT 9 and
10 are the left and right channels of the digital input.
MME column represents general application's I/O:
Ex.) WinAmp, WaveLab (non ASIO mode), Cakewalk, Audition, Vegas, etc.
WDM column represents Multi-MME application’s I/O:
Ex.) SONAR (WDM/KS mode), PowerDVD, WinDVD, etc.
ASIO column represents ASIO application’s I/O:
Ex.) Cubase, Logic, Reason, Nuendo, SONAR (ASIO mode), Samplitude, etc.
GSIF column represents GSIF applications like GigaStudio.
NOTE: Some applications support multiple driver modes.
- 26 - 26