FiberPlex FOM-1090 - Manual (Page 13)

Inserting a Module
1) Attach an ESD‐preventative wrist
or ankle strap, following its
instructions for use.
2) Disconnect and remove all
interface cables from SFP Module.
3) If the SFP Module has a Bail Clasp ,
close the Bail Clasp before
inserting the SFP Module.
4) With the gold finger connector on the bottom and the label on the top, line up the SFP Module
with the empty cage and slide it in making sure that it is completely inserted and seated in the
cage.
Removing a Module
1) Attach an ESD‐preventative
wrist or ankle strap,
following its instructions for
use.
2) Disconnect and remove all
interface cables from SFP
Module.
3) Release the latching
mechanism.

Bail Clasp – Open the bail clasp on the SFP Module with your finger in a downward
direction.

Actuator Button – Gently press the actuator up (or in) while pulling the body of the SFP
Module to release the SFP Module from the cage.

Mylar Tab – Pull the tab gently in a straight outward
motion until it disengages from the port. Make sure the
tab is not twisted when pulling as it may become
disconnected from the SFP Module.

Slide Tab ‐ With your thumb, push the slide tab on the
bottom front of the SFP module in the direction of the
equipment to disengage the module from the line card
port. If you pull on the SFP module without disengaging
the tab, you can damage the SFP module.
4) Grasp the SFP Module between your thumb and index finger and
carefully remove it from the port
5) Place the SFP Module on an antistatic mat, or immediately place it in a static shielding bag or
container