Flowserve Valtek Mark 200 - Manual (Page 13)

13
Mark 200 Control Valve FCD VLENIM0200– 12/12
flowserve.com
Figure 8 – Exploded drawing of a DIN Mark 200 with screwed-in seat ring; mounting shown for electric actuator
Linear Thrust Unit 12.5
Lock Nut 12.4
Stroke Indicator Disk 5.9
Hex Nut 5.7
Hex Nut 3.6
Gland Flange 3.4
Packing Box 3.3
Bottom Ring 3.2
Bonnet 3.1
Hex Nut 1.4
Extension Sleeve 1.5
Body Gasket 1.2
Trim 2.2 + 2.4
Screwed Seat 2.1
Seat Gasket 2.5
Stud Bolt 1.3
Body 1.1
Part Item Available Materials
Body 1.1 1.0619 1.5419 1.7357 1.7379
Bonnet Gasket 1.2 Pure Graphite on Support Plate from C-276
Stud Bolt 1.3 1.7218 (KG) 1.7709 (GA) 1.4923 (V)
Hex Nut 1.4 1.7218 (KG) 1.7709 (GA) 1.4923 (V)
Extension Sleeve 1.5 1.7218 (KG) 1.7709 (GA) 1.4923 (V)
Screwed Seat 2.1 1.4122 1.4922
Contoured Plug 2.2 1.4122 1.4922
Spring Pin 2.3 A2
Stem 2.4 1.4122 1.4922
Profil Ring 2.5 Pure Graphite
Bonnet 3.1 1.0460 1.5415 1.7335 1.7383
Bottom Ring 3.2 1.4922
Packing Box 3.3 Pure Graphite Rings
Gland Flange 3.4 1.4922
Stud Bolt 3.5 1.4923 (V)
Hex Nut 3.6 1.4923 (V)
Yoke Rod 5.1 1.4122
Flange 5.2 1.0460
Hex Nut 5.3 A2 - 70
Stroke indicator scale 5.4 Aluminium
Hex Bolt 5.5 A2 - 70
Washer 5.6 A2
Hex Nut 5.7 A2 - 50
Stroke indicator Disk 5.9 1.0038
Threaded Ring 5.10 1.0460
Set Screw 5.11 45 H