Flowserve StarPac II Control Valves - Manual (Page 15)

Override Condition - Indicates the controller is currently not
capable doing any more to achieve the setpoint (or valve
position). This can be any of the trip conditions, or a mechanical
or software travel limit has been reached and the controller has
exceeded the 5 percent current limit.
Sensor Malfunction - One of the sensors has a suspect output.
(See sensor errors for detail.)
Device Malfunction - The electronics has an internal error.
(See device errors for detail.)
System Information - Allows the user to check the factory hardware
configuration for reference or spare parts. The following list shows
the items listed:
Valve Serial Number: Spring:
Trim Number: Spring Type:
Trim Characteristic: Air Action:
Trim Type: Electronics S/N:
Pressure Class: EPROM Version:
Valve Model: Sensor Rating:
Flow Direction: Sensor Drawing No.:
Body Size: P1 Serial Number:
Body Material: P2 Serial Number:
Packing Style: P1 Calibration Date:
Packing: P2 Calibration Date:
Gasket Material: Miscellaneous No. 1:
Actuator Size: Miscellaneous No. 2:
View Registers - Allows the user to view any internal
integer or floating point Modbus register using the register
map provided (see appendix for a list of registers). String
registers cannot be viewed with this function.
Tune Menu
The T
UNE menu is used to view and configure the controller
variables and gains, change modes, and reset the totalizer. The
Com-
mand
Con-
fig
Sta-
tus
Cal-
brat
Set-
pnt
Mode
Tune
Next
Prop
Band
Rset
Rate
Next Der
Time
PI
Ac
Figure 4: Tune Menu Tree
T UNE menu is arranged as shown in Figure 4.
Mode - Has two options for defining the current mode and the
source of the mode.
D
tn
PV
Scal
PV
Slct
Rset
Totl
StarPac II User Interface Manual 9