Flowserve URB 2 - Manual (Page 17)

7
Menu Start
Start logo
The start logo appears for approx. 2 minutes after
restarting the equipment. During this period the
parameters of the equipment connected via CAN
bus are downloaded.
Device: URB2
Version: 311.131.xx
Date: July 2005
Operati ona l
Home Control Limiter
Level
45 %
Conductivity StdBy
MAX 6000
ACT. 4800µS/cm
Pressure
MAX
ACT. bar
Temperature
MAX 300
ACT. 150°C
Home Control Limiter
Choice
Language
System configuration
Baud rate
Brightness
About URB 2
Service menu
GESTRA
Home
The start window in the display shows all possible indications and readings. Note that the system
configuration determines what is actually indicated.
. To select the basic settings press the navigation
wheel. The selection of the menus will be
indicated.
2. To select a menu turn the navigation wheel and
then press it to confirm the selection.
■
To choose another language select menu
Language.
■
If you want to update the node IDs of the
connected equipment or to activate equipment for
viewing select the menu System Configuration.
■
To update the baud rate select the menu Baud
Rate.
■
To change the properties of the display select the
menu Brightness.
■
To view information on the equipment select the menu About URB 2.
■
To disable equipment settings or to carry out the key test select the menu Service menu.