Flowserve URB 2 - Manual (Page 5)

5
Important Notes
Usage for the intended purpose
The operating & display unit URB 2 may only be used in conjunction with GESTRA CAN bus devices.
Any type of use differing from the usage described above must be considered as improper. The resulting
risk will have to be borne by the user alone. The manufacturer hereby expressly rejects any claims for
any damage resulting from improper usage.
Safety note
The equipment must only be installed and commissioned by qualified and competent staff.
Retrofitting and maintenance work must only be performed by qualified staff who – through adequate
training – have achieved a recognised level of competence.
Explanatory Notes
Scope of supply
URB 2
 Operating & display unit URB 2
 Connecting socket type M 2, with 5 poles, A-coded
 Connecting socket type M2, with 5 poles, A-coded, with terminating resistor 20 Ω
 Installation manual
 Sticker with password
System description
The URB 2 is an operating & display unit for all GESTRA CAN bus devices that uses the CANopen
protocol to register all the data telegrams coming from the sensors, control units and actuators that
are provided by the CAN bus.
The following readings, parameters and settings can be displayed and – with the exception of the
actual values – also be changed by means of the URB 2.
ATEX (Atmosphère Explosible)
According to the European Directive 94/9/EC the equipment must not be used in explosion risk areas.