Fluke Biomedical VT305 - Manual (Page 21)

Gas Flow Analyzer
Start Up
7
High Pressure
The high pressure port is used to measure pressure more
than 200 mbars. Figure 4 shows the high pressure port on
the Product.
High
Pressure
gyo009.eps
Figure 4. High Pressure Port
Note
For measurements to a maximum of 200 mbar,
Fluke Biomedical recommends you use the
differential pressure port. Accuracy is 100 times
higher.
 Caution
To prevent damage to the high-pressure
sensor, do not measure pressure more than
15 bar.
O
2
Measurement Cell
The Product has an interface for an O
2
measurement cell.
See Figure 5. For more information, see the O
2
Sensor
section in this manual.
O
2
– Measuring Cell
gyo010.eps
Figure 5. O
2
Cell
Controls
Table 3 is a list of the front-panel controls.